Table of Contents
Advertisement
Mounting the Lens
Raise the lens clamping lever and remove the
mount cap.
Mount Cap
To mount the lens, align the indentation at the
top center of the lens mount with the center
mark of the lens.
Mark
Secure the cable through the cable clamp, and
plug it into the LENS connector.
LENS Connector
Adjust the lens flange back.
Please refer to the lens instruction manual for guidance
on lens handling.
When the lens is removed, install the mount cap to
protect the device.
Preparation: Mounting the Lens and Performing the Flange Back and White Shading Adjustments
If images are not clearly focused at both telephoto and wide-
angle positions during zoom operations, adjust the flange
back (distance from the lens mounting surface to the image
formation surface).
Lens Clamping
Lever
Please also refer to the lens instruction manual for directions
on adjustment and locations of individual lens parts.
Adjusting the Lens Flange Back
Mount the lens on the camera.
Make sure you connect the lens cable.
Approximately 3m
Place the flange back adjustment chart about
3 m from the lens and adjust the lighting on
the chart to obtain an appropriate video
output level.
If the video level is too high, use the filters or the
shutter.
Loosen the F.f (Flange focus) ring clamping
screw.
F.b (Flange back) may be indicated on some lenses.
Set the zoom ring to the telephoto position,
either manually or by electric drive.
Aim the lens at the flange back adjustment
chart and turn the distance ring to bring the
chart into focus.
Set the zoom ring to the wide-angle position
and turn the F.f ring to bring the chart into
focus.
While focusing, take care not to move the distance ring.
Advertisement
Table of Contents
