Table of Contents
Advertisement
Shooting procedures for the ONE SHOT mode of
INTERVAL REC
Following basic operations of shooting and
recording according to “Basic Procedures”,
lock the camera securely.
Press the REC button.
The AJ-HPX3100 automatically goes into ONE
SHOT pause mode after the specified REC TIME.
Performs recording for the duration specified under
the REC TIME option by pressing the REC button,
and returns to ONE SHOT pause mode.
Press the STOP button.
The video stored in memory are generated as one clip.
To divide clips or to change the P2 card used for
recording
When replacing the P2 card, check the access LED, etc. to
make sure that access has been terminated before
removing the P2 card.
To stop the ONE SHOT mode of INTERVAL REC
When INTERVAL REC HOLD is set to [OFF], the mode
returns to ordinary recording mode if the POWER switch of
the unit is turned OFF.
If INTERVAL REC HOLD is set to [ON], the ONE SHOT
mode will not change even if the POWER switch is turned
OFF.
During INTERVAL REC mode general notes
Interval recording does not record audio.
During interval recording, all operation buttons other than
STOP (REW, FF, PLAY/PAUSE) are disabled.
If the AJ-HPX3100 is turned off during interval recording,
the video stored in memory is recorded onto the P2 card,
and then the camera automatically turns off.
When recording starts, the time code (TCG) display may
not update until the unit recognizes the P2 card.
remove the card accidentally, restore clips. However, even
if the clips are restored, the last 3 to 4 seconds up to a
maximum of about 10 seconds of the recording may be
lost if the P2 card is removed while recording onto multiple
P2 cards. For more information on how to fix clips, see
[Restoring Clips] (page 126).
Operating mode limitations
INTERVAL REC function does not work when:
the LOOP REC MODE menu option is set to “ON”.
the ONE CLIP REC MODE menu option is set to
“ON”.
Native mode, 24P or 24PA mode is selected in the
REC FORMAT or CAMERA MODE menu option.
The REC SIGNAL menu option is set to “SDI”.
[Recording Setting and Operation Mode] (page 46)
Thumbnail operation does not work during the INTERVAL
REC mode operation. Press the STOP button before
operating thumbnails.
When standby time is set to 1 minute or more or when in
ONE SHOT mode, the following restrictions apply even
though the menu can be operated during stand-by mode.
The respective settings or SYSTEM MODE, REC
SIGNAL, REC FORMAT, CAMERA MODE, AUDIO
SMPL RES, 25M REC CH SEL, and PC MODE cannot
be changed.
The respective settings for SD CARD READ/WRITE,
LENS FILE CARD R/W, READ USER DATA, READ
FACTORY DATA, reading SCENE FILE, and CAC FILE
CARD READ cannot be executed.
Recording and Playback: Interval Recording
Advertisement
Table of Contents
