Fill Hose, Drain Hose, Wiring Harness Replacement; Link Support Wire Position; Front Trim Replacement - Fisher & Paykel DishDrawer DD605 Service Manual

8.22 Fill Hose, Drain Hose, Wiring Harness Replacement

8.22.1 Remove the tub and turn it over by rotating it anti-clockwise (refer
Section 8.5).
8.22.2 Remove the wiring cover (refer Section 8.13).
8.22.3 Disconnect the component you need to replace (e.g. fill hose, drain
hose, wiring harness) from the tub.
8.22.4 Undo the link clips and chassis clips.
Do this one clip at a time, marking the position of the hoses and
harness at each clip and re-closing it after the component is
removed to keep the other two components in their correct
positions. The faulty component can now be disconnected from the
chassis end and removed.
8.22.5 Refit in the reverse manner, ensuring the link and chassis clips are
clamping the components in their correct location.

8.23 Link Support Wire Position

8.23.1 If latches are resetting, this can be caused by the link support wire
being positioned too low and allowing the hoses and harness to get
between the tub and the latch.
8.23.2 To check the position of the wire, remove the tub, and remove the
centre link clip from the wire.
8.23.3 Swing the wire to the left hand side of the chassis.
8.23.4 It should rest approx. 15mm (3/4") above the slide mounting
bracket.
8.23.5 If not, carefully bend the wire while supporting it at the rear so as
not to stress the mounting bracket.

8.24 Front Trim Replacement

8.24.1 Bottom tub only:- Remove the toe kick (refer Section 8.3) and
cowling (refer Section 8.4).
8.24.2 Remove the drawer front (refer Section 8.1), handle (refer Section
8.2), and tub (refer Section 8.5).
8.24.3 Remove both the left hand and right hand yokes (refer Section 8.18).
This is to prevent damaging the locating tab at the front of each yoke
where it slides up into the rear of the trim.
8.24.4 Remove the trim by releasing the trim clips with long-nose pliers.
8.24.5 Refit in reverse manner.
55
599447A