Hall Sensor; Heater Plate And Motor Assembly - Fisher & Paykel DishDrawer DD605 Service Manual

8.15 Hall Sensor

8.15.1 Remove the wiring cover (refer Section 8.13).
8.15.2 Unplug the wiring connection from the hall sensor.
8.15.3 Gently press the hall sensor locking tab in the direction shown and lift
the hall sensor out.
8.15.4 Refit in reverse manner.

8.16 Heater Plate and Motor Assembly

8.16.1 Remove the drawer front (refer Section 8.1), baskets, filter plate
(refer Section 8.11) and rotor assembly (refer Section 8.12).
8.16.2 Remove the tub and turn it over by rotating it anti-clockwise (refer
Section 8.5).
8.16.3 Remove the wiring cover (refer Section 8.13).
8.16.4 Remove the element connector cover and the element wiring
connector.
8.16.5 Remove the drain hose and the heater plate earth wire.
8.16.6 While lifting the locking tab (indicated) on the outer locknut, rotate
the outer locknut anti-clockwise until it comes free of the tub tabs,
then remove it.
8.16.7 Take care not to damage any motor wiring as the locknut is
turned, or the flap valve slot when the locknut is removed.
8.16.8 Lift the rear of the heater plate and motor assembly clear of the
tub and slide the drain spigot out of the tub drain area.
8.16.9 Remove the inner locknut and motor shim to release the motor
assembly from the heater plate.
8.16.10 Take care with the seals between the motor assembly and the
heater plate, and the heater plate and the tub. These seals and
their corresponding sealing surfaces must be clean and the seals
correctly placed during reassembly.
8.16.11 Check both the drain hose 'O' ring and the drain spigot 'O' ring for
damage and replace them if necessary.
reassembly.
8.16.12 Replace the flap valve.
8.16.13 Reassemble in reverse manner, ensuring all the locking ring tabs
are engaged.
Lubricate before
51
599447A