Electronic Controller; Filter Plate; Rotor - Fisher & Paykel DishDrawer DD605 Service Manual

8.10 Electronic Controller

8.10.1 Remove the drawer front (refer Section 8.1) and the handle (refer
Section 8.2) (optional).
8.10.2 Disconnect all the wiring connectors on the controller.
8.10.3 Use a flat blade screwdriver to release the clip on the right-hand side
of the controller by firmly pushing it in towards the tub. Do not lever
against the clip or there is a risk of breaking it.
8.10.4 The bottom of the controller can now be lifted out to an angle of about
45°, at which point the top of the controller will come free.
8.10.6 Refit in reverse manner, ensuring the controller is located correctly in
behind the tub flange at the top.

8.11 Filter Plate

8.11.1 Remove the lower racks and baskets from the tub.
8.11.2 Remove the drain filter assembly.
8.11.3 Rotate the filter plate locknut anti-clockwise to release the filter plate
from the rotor assembly.
Note: Over-rotating the locknut will also release the rotor.
8.11.4 Lift the filter plate clear.
8.11.5 Refit in reverse manner.

8.12 Rotor

8.12.1 Remove the filter plate (refer Section 8.11).
8.12.2 Rotate the rotor locking ring anti-clockwise to release it from the
motor housing and lift out.
8.12.3 The rotor assembly is not serviceable and if damaged should be
replaced.
8.12.4 Refit in reverse manner, taking care to align the 4 legs on the rotor
with the slots in the motor housing. The rotor can only be placed in
one position.
The short leg goes into the middle slot indicated by the arrow on the
motor housing.
49
599447A