Continuous Cycle Test Mode; Temperature & Voltage Display Mode - Fisher & Paykel DishDrawer DD605 Service Manual

5.1.6 Continuous Cycle Test Mode

In this level the DishDrawer™ can be run continuously in any wash cycle. Once the cycle has finished, the DishDrawer™
automatically restarts the same wash cycle.
Press POWER to skip continuous cycle. As this is the last level, doing this will exit diagnostics.
Press START/PAUSE to enter continuous cycle.
Once selected, the LCD segments turn on and off to indicate the DishDrawer™ is in continuous cycle and the cycle starts
straight away (for integrated models the LED above the start/pause button will be orange instead of green to indicate the
DishDrawer™ is running in continuous cycle). It will run the last cycle that had been selected prior to going into
diagnostics mode.
If it is wished to run a different cycle, it will be necessary to exit diagnostics, turn the DishDrawer™ on as normal, and
select the cycle required. Then turn the DishDrawer™ off again, re-enter diagnostics and restart the continuous cycle
mode as above.
Press POWER to exit at any time.
Cycle Count Retrieval
(Not available on integrated or flat door models.)
To display the cycle count on the LCD screen, pause the DishDrawer™ while running a continuous cycle. The two bytes
of the cycle count will be displayed alternately.
To calculate the total DishDrawer™ cycle count, use the formula below.
Cycle Count = Low byte + (200 x High byte).
The first byte displayed is the low byte
Eg. Low byte = 156
High byte = 2
Cycle count = (200 x 2) + 156 = 556.
Note: the cycle count can also be retrieved in optical download mode, (refer Section 5.1.2).
5.1.7 Temperature & Voltage Display Mode
(Not available on integrated or flat door models.)
During a wash cycle, the current water temperature or the power supply rail voltage of the controller can be displayed on
the LCD instead of the time remaining. To enter temperature/voltage display mode, start a wash cycle as normal.
Initiate a keylock by pressing and holding the KEYLOCK button for 4 seconds.
Once in keylock mode, press and hold START/PAUSE for 8 seconds to enter temperature display mode. The display
now alternates between a °C symbol and the water temperature. Pressing the START/PAUSE again changes the
display to alternate between an °E symbol and the power supply rail voltage of the controller.
To cancel temperature/voltage display mode, press the POWER button.
27
599447A