Service Procedures; Drawer Front; Handle And Lcd Display - Fisher & Paykel DishDrawer DD605 Service Manual

8

SERVICE PROCEDURES

CAUTION:- Due to the use of an electronic switch mode power supply, all internal
components, regardless of supply voltage, should be treated as live to earth (i.e. equal
to the mains supply voltage) when power is supplied to the DishDrawer
8.1

Drawer Front

8.1.1 Open the drawer.
8.1.2 Locate the drawer pins on either side of the tub.
If the pins cannot be accessed, remove the tub from the
slide first (refer Section 8.3).
8.1.3 Use pliers to pull on the pin and remove it. Support the drawer front
with your hand while doing this to prevent it dropping onto the floor.
8.1.4 With both pins removed, the bottom of the drawer front can now be
eased forward slightly.
8.1.5 Pull the drawer front down to free it from the handle and the top
locating slots in the tub.
8.1.6 Remove the earth wire from the tab on the drawer front. (If it is an
integrated model, it will be necessary to unplug the integrated
badge from the badge isolator.)
8.1.6 Refit in reverse manner, ensuring the earth wire is reconnected,
drawer slides are fully forward and the pins secure through the
hooks on the front end of the slides.
Note: When reinserting the pins, ensure that the dividing web is vertical as
shown.
8.2

Handle and LCD Display

8.2.1 Remove the drawer front (refer Section 8.1).
8.2.2 Disconnect the LCD wire harness from the controller.
8.2.3 The handle slides onto the flange at the top of the tub. Push the
handle from the right to the left to release it.
8.2.4 The handle may now be lifted clear by pulling it forwards.
8.2.5 The LCD display is held in place by a spring tab on one end and a
clip in the centre. Use a small blade screwdriver to carefully
release the tab and centre clip as shown. The LCD assembly can
now be removed.
8.2.6 The wiring harness can now be unplugged from the LCD circuit
board.
8.2.7 Refit in reverse manner.
45
599447A
.
™