Table of Contents
Advertisement
69
9.24 Water Inlet Valve
Remove the lower tub, refer section 9.6.
1.
Remove the mains filter cover, refer section 9.23.
2.
Partially lift the inlet valve up out of the housing.
3.
Disconnect the water inlet hose connection,
4.
CAUTION - water will drip.
The water valve can now be removed up and out of
5.
the housing.
Remove the wire harnesses, and mark which fill hose
6.
goes to the top on a double product. Unclip the hose
clips by pushing the ends apart sideways, then
remove the hoses from the valve.
Refit in reverse manner.
7.
9.25 Fill Hose, Drain Hose, Wiring Harness Replacement
Remove the tub and turn it over by rotating it
1.
anticlockwise (refer section 9.6).
Remove the wiring cover, refer section 9.15.
2.
Disconnect the component you need to replace (e.g.
3.
fill hose, drain hose, wiring harness) from the tub.
Undo the link clips and chassis clips, do this one
4.
clip at a time, marking the position of the hoses
and harnesses at each clip and re-closing it after
the component is removed to keep the other two
components in their correct positions. The faulty
component can now be disconnected from the
chassis end and removed.
Refit in reverse manner, ensuring the link and chassis
5.
clips are clamping the components in their correct
location.
9.26 Link Support Wire Position
If the latches are resetting, this can be caused by
1.
the link support wire being positioned too low and
allowing the hoses and harnesses to get between the
tub and the latch.
To check the position of the wire, remove the tub, and
2.
remove the centre link clip from the wire. Swing the
wire to the left hand side of the chassis.
It should rest approx 15mm (3/4") above the slide
3.
mounting bracket. If not, then carefully bend the wire
while supporting it at the rear so as not to stress the
mounting bracket.
D
Wiring Harness
Link Clip
15mm (3/4")
D
Fill Hoses
D
Water Inlet Hose
Chassis Clip
Hide quick links:
Advertisement
Table of Contents
