Show Off / Showroom Wash Mode - Fisher & Paykel DishDrawer DD605 Service Manual

599447A

5.1.8 Show Off / Showroom Wash Mode

This mode initiates a shop show off display and wash operation demonstration.
With the DishDrawer™ powered up and turned on, the show off mode is entered by pressing and holding the ECO and
POWER buttons simultaneously for 5 seconds. Ensure that ECO is pressed first.
The DishDrawer™ is now in the show off mode and cycles through all of the LED & LCD segments.
Pressing the POWER button now puts the DishDrawer™ into the showroom wash mode. Before running this mode, the
tub should be filled with water until it is almost touching the underside of the spray arm. The showroom wash is started
by pushing the START/PAUSE button whereby the following cycle is run:-
The lid is pulled down.
The wash motor starts and runs for 4 minutes.
The wash motor stops.
The lid is lifted.
The display counts down to zero throughout this cycle.
The DishDrawer™ turns off at the end of this cycle.
The DishDrawer™ is still in the showroom wash mode however, and it can be re-run by pushing POWER and then
START/PAUSE. Once show off/showroom wash mode has been initiated, the mains power supply must be removed to
exit out.
Playing Tunes
Once in showroom mode, holding the START/PAUSE button down for 3 seconds will start a tune playing. Pressing the
START/PAUSE button again will toggle the tune between Bach and the Star Spangled Banner. This feature is not widely
known about, may not be present in all models and may be removed in future products.
28