Option Adjustment Mode; How To Change Setup Options; Rinse Aid / Water Supply Hardness/Auto Power/End Of Cycle Beeps/Closed Drawer Option/Clean/Dirty Dish Symbol; Rinse Aid Setup (Ra) - Fisher & Paykel DishDrawer DD605 Service Manual

599447A
4

OPTION ADJUSTMENT MODE

4.1

How to Change Setup Options

4.1.1 Rinse Aid / Water Supply Hardness/Auto Power/End of Cycle
Beeps/Closed Drawer Option/Clean/Dirty Dish Symbol
To enter this setup mode, press POWER, then hold the ECO touch switch and KEYLOCK button simultaneously for 5
seconds, ensuring that ECO is pushed first. Once the setup mode is entered a beep is emitted and the LCD displays the
letters rA. Pushing the START/PAUSE button allows the user to scroll through and change the following options:-

Rinse Aid Setup (rA)

Water Supply Hardness Setup (hd) – only available on water softener models
Auto Power Option (AP)
End of Cycle Beeps (EC)
Closed Drawer Option (Ld).
Clean/Dirty Dish Symbol (dS)
Note: there is no dry enhancement mode for DD605.
Integrated:- On an Integrated DishDrawer™, where there is no display, the user can still tell which option they have
chosen by using the lights showing on the integrated badge as follows:-
Rinse Aid Setup (red light above Start/Pause button)
Water Supply Hardness (green light above Start/Pause button) – only available on water softener models
Auto Power Option (orange light above Start/Pause button)
End of Cycle Beeps (green light above Start/Pause button and ECO light is red)
Closed Drawer Option (red light above Start/Pause button and ECO light is red)
Clean/Dirty Dish Symbol (no light above buttons, ECO light is red)
Note: there is no dry enhancement mode for DD605.
Push POWER at any time to exit this setup mode.
4.1.2 Rinse Aid Setup (rA)
The current rinse aid setting is shown using the red LEDs on the touch switch panel.
The amount of rinse aid dispensed into a rinse cycle can be varied to suit the level of hardness of the local water supply.
It can be set to 1 - 5 dispensing levels.
(1 = approx 0.5mls ( / teaspoon) of rinse aid, 5 = approx. 2.5mls (½ teaspoon) of rinse aid.
1
10
Push KEYLOCK to advance the rinse aid setting. Once the desired setting is achieved, push POWER to exit. The rinse
aid index is stored in EE memory, so even with the power removed the rinse aid level is retained.

4.1.3 Water Supply Hardness Setup (hd)

The current supply hardness setting is shown using the red LEDs on the touch switch panel. One of five settings should
be selected according to the known hardness of the supply water.
No LED Water Softener turned off, continuous bypass of softener
1 LED 150-250 ppm water supply hardness
2 LEDs 250-350 ppm water supply hardness
3 LEDs 350-450 ppm water supply hardness
4 LEDs 450-550 ppm water supply hardness
5 LEDs 550-625 ppm water supply hardness
Push KEYLOCK to advance the Water Softener setting. Once the desired setting has been achieved, push POWER to
exit.
Selection of a setting affects how the electronic controller diverts supply water, how much water is treated, and how much
salt is used in regeneration, in a manner that optimises the performance of the water softener.
20