Wiring Cover; Tub Disconnection - Fisher & Paykel DishDrawer DD605 Service Manual

599447A

8.13 Wiring Cover

8.13.1 Remove the drawer front (refer Section 8.1).
8.13.2 With the drawer opened, remove the tub (refer Section 8.5).
8.13.3 Carefully release the four wiring cover clips from the front lower section of the
tub, taking care not to damage them.
8.13.4 Release the three clips on the underside of the tub that attach the wiring cover
to the motor assembly outer lock nut.
8.13.5 Pull the tub fully open and lift it up at the front (this makes it easier to remove
the wiring cover from the rear of the tub).
8.13.6 The wiring cover may now be carefully moved forward and downward to
release it from the rear of the tub.
8.13.7 To reassemble, first ensure that the wiring harnesses, drain hose and fill hose
are located in their correct positions.
8.13.8 Then refit in reverse manner.
Note: It may be found it easier to remove and rotate the tub anti-clockwise before
removing the wire cover.

8.14 Tub Disconnection

8.14.1 Remove the drawer front (refer Section 8.1).
8.14.2 Remove the wiring cover (refer Section 8.13).
8.14.3 Disconnect the fill hose from the dispenser, or water softener if fitted (water
may drip).
8.14.4 Disconnect the chassis harness plug from the controller.
8.14.5 Remove the wiring cover and the element connector cover.
8.14.6 Disconnect the element harness plug and earth wire from the element plate.
8.14.7 Unclip the drain hose cuff from the motor assembly, taking care not to
misplace the non-return flap valve.
8.14.7 Unclip the drain hose, fill hose and the wiring loom from the under side of the
tub.
8.14.8 Remove the tub.
8.14.9 Refit in reverse manner.
Note: When replacing a fill hose, drain hose or wiring harness, transfer the link
support clip markings from the old parts to the new.
50