Replacing A Fill Hose,Drain Hose Or Wiring Harness - Fisher & Paykel DishDrawer DD60 Service Manual

8.19 Replacing a fill Hose,Drain Hose or Wiring Harness

1 Remove the tub and turn it over by rotating it
anticlockwise (refer section 8.13).
2 Remove the wiring cover, refer section 8.16.
3 Disconnect the component you need to replace
(e.g. fill hose, drain hose, wiring harness) from the
tub.
4 Remove the tub rib clip at the rear of the tub by
pushing it up and out against the snap barb with
either your finger or a flat blade screwdriver to
release (Fig 1, 2, 3)
5 Open the tub rib clip by flicking up the snap barb on
the side of the clip. (Fig 4)
6 Remove the link support clip from the link support
rod as shown on following page. (Fig 5). to open the
link support clip, twist the thinner arm backwards to
unclip and remove the component to be replaced.
7 Open and remove both chassis link clips, by pressing
the snap barbs inwards with two fingers, as shown
on the following page. (Fig 6)
8 For the top tub only, open the top link mount by
inserting a flat blade screwdriver into the snap barb
and twisting, then remove the link component being
replaced. (Fig 7)
9 To gain access to the lower chassis mounts, remove
the chassis module cover shown on the following
page (Fig 8). To open the chassis mount , insert a
screwdriver into the snap barb and twist. Remove the
component to be replaced. (Fig 9)
!0 Unattach the link component (drain hose, fill hose
or harness) from it's connection point at the chassis
module and remove.
!1 Attach the new link component at the tub end and
route the new link component under the tub and
through the tub rib clip.
!2 Ensure all the marks on the link components match
up to the top of the clip when the clip is closed, as
shown. (Fig 10)
!3 Insert the tub rib clip back into the rear tub ribs, and
ensure the clip is securely clipped into the rib. (Fig
11)
!4 Ensure the harness is sitting flat in the clips, then
reinstall the link support clips at the marked points
on the link components.(fig 12)
!5 Push the link components back into the chassis
mount at the marked points and close by pressing
firmly. (fig 13 & 14)
!6 Refit the chassis module cover, ensure the clips are
located correctly.
!7 Ensure there is no twist in the link betwen the tub
and the link support. (Fig 15)
!8 Fit the chassis side clips to the link assembly, the rear
should be approx 250mm from link support clip, the
front should be 160mm from link support clip. (Fig 16
& 17)
!9 Place the tub back on the slides, making sure the link
is not twisted, and ensure the tub closes correctly.
(Fig 18 & 19)
8 SERVICING PROCEDURES
tub rib clip
Fig 1
Fig 2
Fig 3
Fig 4
61