Service Requirements; Health & Safety; Electrical Safety; Electrostatic Discharge - Fisher & Paykel DishDrawer DD605 Service Manual

599447A
1

SERVICE REQUIREMENTS

1.1 Health & Safety
Note: When servicing the DishDrawer™, Health and Safety issues must be considered at all times. Specific safety
issues are listed below with their appropriate icon. These are illustrated throughout the service information to remind
service people of the Health and Safety issues.

1.1.1 Electrical Safety

Ensure the mains power has been disconnected before servicing the DishDrawer™. If the mains supply is
required to be on to service the DishDrawer™, make sure it is turned off when removing any electrical
component or connection to avoid electrical shock.

1.1.2 Electrostatic Discharge

An anti-static strap is to be used as electrical static discharge (ESD) protection when servicing electronic
components.

1.1.3 Good Working Practices

Ensure the work area is in a tidy and orderly condition at all times so as not to cause a hazard while service
work is being completed. Always clean and tidy the DishDrawer™ and work area after service is completed.

1.1.4 Isolate Water Supply

Turn off the water connection tap before servicing.

1.1.5 Water Leak Check

Check for water leaks as part of the testing after the service has been completed.

1.1.6 Insulation Test

Megger test to check insulation.
Warning: Short together the phase and neutral pins on the plug so as not to damage any electronic
circuitry.
8