Fisher & Paykel DishDrawer DD605I Integrated Panel Preparation Manual
Fisher & paykel dishdrawer integrated panel preparation
Hide thumbs
Also See for DishDrawer DD605I:
- Hardware manual (32 pages) ,
- User manual (112 pages) ,
- Integrated panel preparation manual (32 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fisher & Paykel DishDrawer DD605I
Summary of Contents for Fisher & Paykel DishDrawer DD605I
- Page 1 Integrated panel preparation DS605I and DD605I models DishDrawer NZ AU GB IE...
-
Page 2: Safety And Warnings
Safety and warnings Cut Hazard Take care - panel edges are sharp. Failure to use caution could result in injury or cuts. Important! Read these instructions completely and carefully. Ensure the product is not plugged in. Installation of DishDrawer® panels requires basic mechanical and electrical skills. Installation must comply with your local building and electricity regulations. -
Page 3: Table Of Contents
Contents Double models Product preparation Single models Product preparation Panel Installation Badge cut-out, handle and mounting bracket Securing the mounting brackets Reconnecting the wires and fitting the panels and a custom toe kick Important! SAVE THESE INSTRUCTIONS The models shown in this User Guide may not be available in all markets and are subject to change at any time. -
Page 4: Double Models
Product preparation Double DishDrawer models 8 mm Air gap Installation diagrams for illustration purposes only The following calculations assume the top of the upper panel is aligned with the top of the adjacent cabinetry. The fi nal panel/cabinetry alignment is achieved by adjusting the feet: width of ALL panels Measure A (the width between adjacent door/drawer fronts) and write it in the fi rst box below, then complete the equation. - Page 5 Toe kick preparation height of toe kick panel Measure D (height from the top of adjacent cabinet door fronts to the fl oor) and write it in the fi rst box below, then complete the equation. i.e 817.5 mm - 0 mm - 735 mm - 12 mm = 70.5 mm Toe kick options The black prefinished toe kick panel is supplied.
-
Page 6: Product Preparation
Product preparation Single DishDrawer models 9 mm Air gap Installation diagrams for illustration purposes only The following calculations assume the top of the panel is aligned with the top of the adjacent cabinetry: width of the panel Measure A (the width between adjacent door/drawer fronts) and write it in the fi rst box below, then complete the equation. -
Page 7: Parts Supplied
n g t h e D i f i n s t a l l i d i a g r a m U s e t h i s Integrated Panel material 16 -20 mm panel thickness Adequately sealed to withstand moisture (50 Parts supplied Panel mounting screws (6) -
Page 8: Badge Cut-Out, Handle And Mounting Bracket
Badge cut-out, handle and mounting bracket Installation diagrams feature double models for illustration purposes only Important! Ensure the product is not plugged in... -
Page 9: Securing The Mounting Brackets
Securing the mounting brackets 16 mm x6 Double models only: Important! Break off the tab at the top of the Lower Mounting Bracket... -
Page 10: Reconnecting The Wires And Fitting The
Reconnecting the wires and fi tting the panels and a custom toe kick (double models only) Important! Ensure the rubber seal between the drawer and panels is kept in place 16 mm x 5 16 mm x5... - Page 12 Copyright © Fisher & Paykel 2007. All rights reserved. The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time.
Need help?
Do you have a question about the DishDrawer DD605I and is the answer not in the manual?
Questions and answers