Lid; Yoke - Fisher & Paykel DishDrawer DD605 Service Manual

599447A

8.17 Lid

8.17.1 Remove tub assembly as per instructions in Section 8.5.
8.17.2 On the right-hand side of the lid, release the two tabs (one at the front, one
at the rear) that clip the lid to the yoke, at the same time pulling the lid
down. Repeat for the left-hand side.
8.17.3 The lid is now free to slide forward out of the chassis through the space
provided in the trim.
8.17.4 Refit in the reverse manner taking care that the lid is fitted the correct way
around. FRONT is printed on both sides on the top of the lid.

8.18 Yoke

8.18.1 Remove the lid (refer Section 8.17).
8.18.2 Release the lid actuator from the bottom of the yoke by pushing with your
thumb against one of the locking tabs.
8.18.3 Slide the front of the yoke downward at an angle until it moves out of the
track in the rear of the trim, and is clear of the chassis flange.
8.18.4 Refit in the reverse manner taking care that the yoke is the correct way
around.
8.18.5 Do not bend the yoke when refitting it. Locate the rear end below the
chassis tab at the rear of the chassis first, then slide the front up in behind
the trim to ensure the front yoke peg locates correctly in the track behind it.
52