Cleaning The Print System; Starting Automatic Print System Cleaning - FP postbase Operator's Manual

96
PostBase Mailing System
11.4

Cleaning the print system

11.4.1 Starting automatic print system cleaning

You should start automatic print system cleaning only if the quality of the imprint is
not good enough (e.g. blank spots in the imprint after longer periods out of use).
Cleaning
• Open the M .
ENU
• Choose P S
RINT
• Choose C
LEANING
A message informs you about the cleaning
process in progress.
• Check the quality of the imprint with a test
print (see page 41).
Intensive cleaning
You should start intensive cleaning if normal
cleaning fails to improve the print quality to
your satisfaction.
• Open the M .
ENU
• Choose P S
RINT
• Choose I
NTENSIVE
submenu.
A message informs you about the cleaning
process in progress.
• Check the quality of the imprint with a test
print (see page 41).
In case of stubborn soiling, even intensive
cleaning may be unable to improve the print
quality as desired. In such cases, you can
manually clean the cartridges (see page 97).
.
YSTEM
in the submenu.
.
YSTEM
C in the
LEANING