FP postbase Operator's Manual page 8

8
PostBase Mailing System
Accessories and consumables
• We recommend to use only approved FP equipment and FP original parts. The
manufacturer FP has established reliability, safety and applicability. The manufac-
turer cannot assess the reliability, safety and applicability for products not approved
by FP, and therefore not vouch for such products.
• Use the supplied power and connection cables or cables that have been approved
by Francotyp-Postalia. Make sure that cables are not damaged.
• Ingestion of the ink can be hazardous. Avoid contact with the eyes. Keep the ink
cartridges away from children. Further instructions for use are enclosed with the ink
cartridges.
• We recommend to use only the batteries provided by Francotyp-Postalia.
The manufacturer FP has established reliability, safety and applicability. Observe
the instructions enclosed with the battery for correct use and disposal.
General safety tips
• Install the PostBase mailing system according to the instructions.
• Do not use attached parts like the weighing platform, label compartment, display,
drawer, ... as 'handles' during transport. The best way to handle the components
is to hold them at the lower part of the housing at the clearances on both sides.
• When you move the PostBase from a cold environment (i.e. below 10 °C / 50°F):
Unpack the PostBase and wait at least 2 hours before connecting the PostBase.
The PostBase requires this period to adapt to the ambient conditions. Any conden-
sation evaporates.
• Use the 'Feeder PostBase' only with the PostBase franking machine. It is not pos-
sible to operate the feeder without the PostBase franking machine.
• Have maintenance and repair work done only by qualified personnel authorized by
Francotyp-Postalia. Otherwise, your warranty may become void.
• Do not be startled while positioning letters. Letter transport will start after a short
delay.