FP postbase Operator's Manual page 122

122
PostBase Mailing System
Issue
Letter transport is
stopped / batch
processing was
interrupted
PostBase signals a jam
although no letters are in
the letter path
...
with manual sealing (sealer)
Envelopes are not properly
sealed
Envelope flaps are not
moistened properly
Possible cause and remedy
Jam. Carefully read the displayed information.
On how to clear a letter jam, please read
chapters 12.2 and 12.3.
The batch counter is turned on. After the pre-set
number of mail pieces have been processed,
PostBase will automatically stop (see chapter 6.3.3.5).
The sensors (light barriers) are soiled.
Clean the sensors (see chapters 12.5 and 12.6).
Stroke your hand firmly over the envelope's / letter
stack's flap area.
Use the special 'sealit' sealing liquid available from
Francotyp-Postalia.
Felts are soiled / dried out.
Clean sealer (see chapter 11.8.1).
Fill 'sealit' sealing liquid (see chapter 11.8.2).
Moistening felt is worn.
Replace rocker with moistening felt (see chapter 11.8.3).
Absorption felt is worn.
Replace absorption felt (see chapter 11.8.3).
Moistening felt incorrectly seated in the rocker.
Correct moistening felt position (see chapter 12.4).
Absorption felt incorrectly seated in the sealer. Surface
is curved.
Check and if necessary correct absorption felt position
in the sealer (see page 115).