FP postbase Operator's Manual page 119

Issue
Scale: no confirmation
beep
User PIN is not accepted
... postage download
Desired amount cannot
be loaded
Function not available
Postage download
procedure aborts
... when using special functions
Advert Only: adverts / text
messages are not printed
on the expected position
on the letter
Print Numbers: the num-
ber is not printed on the
expected position on the
letter
Seal Only: letters are
transported, but not
sealed
Possible cause and remedy
Adjust tone signals (see chapter 10.3).
Did you select the correct user? Press B
the correct user.
Contact the system administrator.
Impermissible amount.
Change amount and repeat loading.
The current user is not authorized to access this
function. Please contact the system administrator.
The PostBase fails to establish connection to the data
center.
Check connection configuration (see chapter 10.9).
Check data center phone number (see chapter 10.10).
Data center issue. Try again later.
Imprint offset is active.
Deactivate the imprint offset or set a suitable value
(see chapter 5.3).
Imprint offset is active.
Deactivate the imprint offset or set a suitable value
(see chapter 5.3).
On the feeder, check if the sealing function is
switched on.
Set the switch to the rear position (seal).
See chapter 6.3.3.2.
Tips for troubleshooting
. Select
ACK
119