FP postbase Operator's Manual page 121

Issue
...
with automatic feeding / sealing (feeder)
Envelopes are not properly
sealed
Envelopes are not sealed
Jam
Letters are not correctly
fed
Letter transport
does not start
Possible cause and remedy
Rub powerfully with your hand over the letter stack
once in the area of the flaps.
Moistening sponge and brush are dried because the
sealant tank was empty over a longer period of time.
Remove sponge and let it soak up completely
(see chapter 11.7.3).
Sponge is dirty or worn.
Clean or replace the sponge (see chapter 11.7.3).
Brush is dirty or worn.
Clean or replace the brush (see chapter 11.7.4).
You have used unsuited envelopes.
Only use envelopes that are suited for sealing by
machine. Observe specifications (see page 143).
Adjust the moistening level (see chapter 11.7.2).
Use the special 'sealit' sealing liquid available from
Francotyp-Postalia.
Sealing is disabled.
Set the switch to the 'seal' position (see chapter 6.3.3.2).
Sealant tank is empty.
Fill more 'sealit' sealing liquid (see chapter 11.7.1).
On how to clear a letter jam, please read
chapters 12.2 and 12.3.
When processing thick letters (>6 mm / 0.24"), use the
'thick letters' function (see page 62).
Adjust the slope inclination (see page 61).
PostBase does not display the Home screen / the
'Batch Processing' pop-up (see chapter 6.3.3.4).
Tips for troubleshooting
121