Selecting The Line Group That The Remote Notification Calls Are To Use; Notification Delay Timer; Notification Interval Timer - Mitel 3000 Administrator's Manual

Mitel 3000
Administrator's Manual
•
Select "Retry attempts".
•
Enter the value from 2 to 15 and press "Confirm".
The default value is set at 2.

Selecting the Line Group that the Remote Notification calls are to use

The outgoing line group to be used for remote notification calls can be changed.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "System".
•
Select "Remote Notification".
•
Select "Outgoing group".
•
Select the group.

Notification delay timer

The time interval between receiving a message and making the first remote notification attempt is
programmable. This is set at 15 minutes (900 seconds) in default and can be set between 1 and 30 minutes
(60 - 1800 seconds).
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "System".
•
Select "Timers".
•
Select "Notification Delay".
•
Enter the value between 60 and 1800 seconds and press "Confirm".

Notification interval timer

If a remote notification fails this is the time the system waits before retrying the call. This is set at 5
minutes (900 seconds) in default. The range is 1-15 minutes (60 - 900 seconds).
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "System".
•
Select "Timers".
•
Select "Notification Interval".
•
Enter the value between 60 and 900 seconds and press "Confirm".
68