Least-Cost Routing Activated Automatically At Set Times; Making A Call With Lcr Activated; Account Codes; To Set Up The Account Code Operation - Mitel 3000 Administrator's Manual

Mitel 3000
Administrator's Manual
Note: When enabling or disabling the LCR feature, the new setting does not take immediate effect. There
can be a delay of up to 1 minute for the setting to take effect.
Note: To program LCR Codes when a T1 or T1 PRI interface card is installed see page 129.

Least-Cost Routing Activated Automatically at Set Times

You can program the Least-Cost Routing feature to be automatically turned on and off twice during a 24-
hour period, enabling you to tailor your call charges through different service providers.
•
From the programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Scroll down until "LCR Timebands" is displayed.
•
Select "LCR On Times."
•
You can enter two times when the LCR feature is activated.
•
Select "LCR Off Times."
•
You can enter two times when the LCR feature is deactivated.
•
A third option, "LCR Weekend" is offered. When this is selected, the LCR service remains active from
Friday night to Monday morning, all off times over the weekend are ignored.
Press the speakerphone key to finish programming

Making a Call with LCR Activated

Place the external call as normal by selecting a line or dialing a line access code (9, 760-769).
The system will not select a line until sufficient digits are dialed to allow the system to select the
appropriate line or substitute the appropriate digits.
You will notice that a line is not selected until the system has received sufficient digits and that if you
select a line the system can choose a different one depending on the code dialed.

ACCOUNT CODES

A programming option can be set which allows codes of four digits to be associated with external calls,
both incoming and outgoing, and these codes are presented on the Call Logging output. Two options are
available. The first is that the entry of account codes is optional and the user can choose to enter the code or
not. The second option is forced and in this case the user must enter the code before they can make an
external call.

To Set up the Account Code Operation

•
From the programming extension, press the PROGRAM key.
•
Select "System Programming".
•
Enter the System Programming Password and select "System".
•
Press the Scroll Down key ( ) until "Account Codes" is displayed.
•
Select "Account Codes".
•
Select "Account Codes On".
The option "Forced Extensions" is presented. This is selected if you wish to have some extensions
programmed so that they must enter an account code before dialing a number.
•
Select "Forced Extensions".
•
Select the extensions.
Press the speakerphone key to finish programming.
.
86