Outgoing Groups; Outgoing Groups Programming When T1 Is Programmed; Outgoing Groups When Pri Is Programmed; Lcr Codes - Mitel 3000 Administrator's Manual

OUTGOING GROUPS

Outgoing groups programming when T1 is programmed

Individual T1 channels can be programmed into the different line groups.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "Outgoing Groups" is displayed.
•
Select "Outgoing Groups" option.
•
Select the group you wish to set up. Up to 11 groups can be set up, each with a corresponding access
code, 9 or 760 - 769.
•
Select the lines to be in the group.
•
The menu updates to show all T1 the backup CO lines and IP Trunks equipped. The lines in the group
are indicated by a "♦".
•
Select the lines that are in the selected group. Lines 1-24 are the T1 lines programmed as equipped in
the Equipped Lines Programming and Lines 25-28 are the CO lines and IP Trunks 1- IP Trunk 12 are
VoIP lines.
In default all lines, T1 and backup CO lines are in group 1 selected by dialing 9.
VoIP lines in default are in group 2 which is selected by dialing 760.

Outgoing Groups when PRI is programmed

In this case all available B-Channels must be programmed into the same line group.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Press the Scroll Down key ( ) until "Outgoing Groups" is displayed.
•
Select "Outgoing Groups" option.
•
Select the group you wish to set up. Up to 11 groups can be set up, each with a corresponding access
code, 9 or 760 - 769.
•
Select either the 'PRI' or the back up CO lines (Line 24 - Line 27 T1 PRI or Lines 30 – 34 if E1
programmed).
•
If PRI is selected all the available B-channels are placed in the selected group.
In default the PRI and CO Lines are all in Group 1, selected by dialing 9.
VoIP lines in default are in group 2 which is selected by dialing 760.

LCR CODES

Selecting Lines when T1 is programmed

When the option to select lines is presented the menu is updated to show all the equipped lines.
•
From the programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Lines".
•
Scroll Down and select "LCR Codes".
•
Select "LCR On" to activate the feature.
•
Enter in a code index (01-50).
•
Enter an input code (Up to 5 digits). Press "Confirm". This is the code dialed by the user.
129
Mitel 3000
Administrator's Manual