Configuring The Hx3 With Lxeconnect; Install Lxeconnect - Honeywell HX3 User Manual

Disconnect HX3 USB cable from host computer.
1. Suspend/Resume or Restart the HX3.
2. Reconnect USB cable from HX3 to host computer.
Solution 2: The host doesn't know you are trying to connect. May mean a bad cable. Try the connection again, with a
known good cable.

Configuring the HX3 with LXEConnect

LXEConnect allows a user to view the HX3 screen remotely on a host computer using an ActiveSync connection:
Requirement : ActiveSync (version 4.5 or higher for Windows XP host computers) must be resident on the host computer.
Windows Mobile Device Center (version 6.1 or higher) is required for a Windows Vista or greater host computer.
ActiveSync and Windows Mobile Device Center for the PC is available from the Microsoft website. Follow Microsoft's
instructions to locate, download and install ActiveSync or Windows Mobile Device Center on your host computer.
Note: For readability in this section, ActiveSync will be used in instructions and explanations. If you have a Windows Vista
or greater operating system on your host computer, replace ActiveSync with Windows Mobile Device Center.
ActiveSync is already installed on the HX3. The HX3 is preconfigured to establish a USB ActiveSync connection to a PC
when the proper cable is attached to the HX3 and the PC.
If the HX3 uses a serial port for ActiveSync, it will be necessary to configure the HX3 to use the serial port. Complete
details on the proper cables and port configuration are included in

Install LXEConnect

1. Install Microsoft ActiveSync on a host computer with a USB port. For details, see
2. Power up the HX3.
3. Connect the HX3 to the host computer using the proper connection cable. Once connected, the ActiveSync dialog
box appears. If using the USB connection, the ActiveSync connection is automatically established.
4. Select "No" for partnership when prompted. Dismiss any ActiveSync dialog boxes warning a partnership is not set
up. It is not necessary to establish a partnership to use LXEConnect. However, if a partnership is desired for
other reasons, one may be established now. More details on partnerships are included in ActiveSync Help.
5. When the ActiveSync screen appears, select Explore.
5 - 4
Initial Setup (page 5-1).
Initial Setup (page 5-1).