Wpa/Leap - Honeywell HX3 User Manual

WPA/LEAP

To use WPA/LEAP, make sure the following profile options are used.
1. Enter the SSID of the Access Point assigned to this profile.
2. Set EAP Type to LEAP.
3. Set Encryption to WPA TKIP.
4. Set Auth Type as follows:
• If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio parameter to Open.
• If the AP is configured to use shared key or passphrase, set the Auth Type radio parameter to Shared.
• If the AP is configured for network EAP only, set the Auth Type radio parameter to LEAP.
5. To use another encryption type, select WPA CCKM, WPA2 AES or WPA2 CCKM for encryption and complete other
entries as detailed in this section.
6. See Sign-On vs. Stored Credentials
7. To use Stored Credentials, click on the Credentials button. No entries are necessary for Sign-On Credentials as the
user will be prompted for the Username and Password when connecting to the network.
8.
9. Enter the Domain\Username (if the Domain is required), otherwise enter the Username.
10. Enter the password.
11. Click OK then click the Commit button.
12. Ensure the correct Active Profile is selected on the Main tab and warmboot. The SCU Main tab shows the device is
associated after the radio connects to the network.
9 - 26
(page 9-16) for information on entering credentials.