Chapter 12 - Battery Charger; Unpacking Your Battery Charger - Honeywell HX3 User Manual

12
Battery Charger

Unpacking your Battery Charger

After you open the shipping carton containing the product, take the following steps:
• Check for damage during shipment. Report damage immediately to the carrier who delivered the carton.
• Make sure the items in the carton match your order.
• Save the shipping container for later storage or shipping.
Introduction
The Battery Charger is designed to simultaneously charge six rechargeable Lithium Ion (Li-Ion) battery packs. The time
required for charging is dependent upon the battery pack temperature and conditions.
The battery charger should be located in an area where it:
Is well ventilated.
• Is not in high traffic areas.
• Locates or orients the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
• Has enough clearance to allow easy access to the power port on the back of the device.
• Is protected from rain, dust, direct sunlight or inclement weather.
This device is intended for indoor use only and requires an indoor AC power source. The charger is not approved for use in
Hazardous Locations.
This device cannot charge/recharge coin cell batteries sealed inside the HX3, if any.
Note: The HX2 and HX3 use the same batteries. Batteries used by the HX3 body worn Voice device are charged, recharged
and analyzed in the HX2 labeled battery charger.
Note: This chapter is intended to familiarize the user with the safety and operating instructions necessary to use the Battery
Charger (Model HX2A310CHGR6US, HX2A311CHGR6WW) to charge rechargeable lithium-ion battery packs
(HX2A301BATTSTD, HX2A302BATTEXT).
This guide should be readily available to all users and maintenance personnel using this battery charger.
12 - 1