Serial Cable; Indicators - Honeywell HX3 User Manual

Serial Cable

Note: Only approved Honeywell cables are to be used for serial communication between the cradle and external devices.
Note: The serial cable port is located on the back of the desktop cradle.
Note: Assemble the AC Adapter and connect it to the desktop cradle. Verify the cradle has a dependable power source.
5. Connect a female DB9 connector to the male DB9 serial port on the back of the desktop cradle. The connection should
be finger tight.
6. The DB9M cradle connector provides limited RS232 functionality, as the following pinout table shows.
Pin Signal
1 Not Connected
2 RXD
3 TXD
4 Not Connected
5 Ground
6 Not Connected
7 RTS
8 CTS
9 Not Connected
Note: Pin 9 of this port does not have power capability. The desktop cradle can not support tethered scanners.

Indicators

The LEDs may flicker between green, amber and red upon the cradle first receiving external power. This is normal. The cradle
is performing a self-check and upon completion, the LEDs will return to their normal state (see below).
1 B1 LED – Back left battery charging bay
2 PWR LED - HX3 docked / on / receiving pow-
er bay
3 B2 LED – Back right battery charging bay
11 - 6
Normal State – Off.
With battery and AC power, normal state may be any state listed in Cradle
LEDs.
Normal State – Off.
With HX3 in, turned On and AC power, normal state is On.
Normal State – Off.
With battery and AC power, normal state may be any state listed in Cradle
LEDs.