Battery Charger; Electrical; Temperature; Dimensions - Honeywell HX3 User Manual

Battery Charger

The battery charger is designed to charge / re-charge standard and extended batteries.
Life Cycle: 500 charge/discharge cycles.

Electrical

Battery packs may leak up to 1mA current through the battery contacts when left in an unpowered battery charger
charging pocket.
Parameter
Power Supply Input Voltage (V AC-IN)
Power Supply Input Frequency (freq)

Temperature

Function
Operating
Battery Pack Charging
Storage

Dimensions

Weight
Length
Width
Height
Plug Type

ASCII Character Equivalents

Values from 1128 through 1255 (hex values 80h through FFh) may also be set. But the conversion of those characters to
printable characters is not standardized. Therefore, they are not included in the table.
Scan Value
1000
1001
1002
1003
1004
1005
1006
1007
1008
1009
1010
Minimum Maximum
-20°C (-4°F) +40°C (104°F)
10°C (50°F) +40°C (104°F)
-20°C (-4°F) +70°C (160°F)
Battery charger: 15 oz / .43 kg (no batteries, no power connection)
Power Supply: 10 oz / .28 kg
11.25" (28.57 cm)
4.25" (10.79 cm)
1.70" (4.32 cm)
IEC320 (3 prong, grounded) / barrel connector
Hex Value
00h
0lh
02h
03h
04h
05h
06h
07h
08h
09h
0Ah
Minimum Maximum
100 VAC 240VAC
47Hz 63Hz
Note
Battery packs will only be charged when their internal
temperature is between 10°C (50°F) and 40°C (104°F)
Battery packs will not begin charging when their internal
temperature is outside this range.
Unit is off.
Full ASCII Code 39
Encode Char.
%U
$A
$B
$C
$D
$E
$F
$G
$H
$I
$J
Note
Auto-switching
Keystroke
CTRL 2
CTRL A
CTRL B
CTRL C
CTRL D
CTRL E
CTRL F
CTRL G
CTRL H
CTRL I
CTRL J
13 - 3