Saving Initial Snapshots; Snapshot File Contents; Initial Snapshots - Studer OnAir 1500 Operating Instructions Manual

5.6.2.2

Saving initial Snapshots

Manual Save Mode
AutoSave Mode
5.6.2.3

Snapshot File Contents

5.6.2.3.1

Initial Snapshots

*.cfg Configuration Snapshot
.
*.ops Operational Snapshot
*.usr User Snapshot
*.key License key Snapshot
Document generated: 06.08.14
Category
Configuration Part
Operational Part
Initial
User Parameters
License Key Info
User
When touching either the Desk Settings - Save button on the Admin
- Config page of the user GUI or one of the Save ... buttons in the con-
figuration tool, the corresponding parameters are saved in the corresponding
data file(s).
Automatic saving of the initial operational (i.e., desk setting) snapshot can
be activated with the configuration tool (refer to
writing a new data file is triggered no longer than 10 seconds after a desk
setting has been changed.
Note: AutoSave mode must be switched Off whenever initial snapshot files are
copied or moved manually.
The initial snapshots contain all configuration parameters of the correspond-
ing sub-system ('container').
All parameters of the configuration type, set by the Config Tool, e.g.
• all I/O sharing-relevant parameters set by the Config Tool
• desk resource definition parameters
• partial output routing snapshots.
All settings within the user GUI and the desk surface:
• the same parameters as an audio snapshot
• the same parameters as the input routing snapshot
• the same parameters as the output routing snapshot
• the same parameters as the assignment snapshot
• monitoring parameters, such as CR or ST2 source
• all user-relevant parameters set by the Config Tool
• all policies-relevant parameters set by the Config Tool
• all department-relevant parameters set by the Config Tool.
This is the only file that belongs to the start-up configuration of the console
(initial snapshot), but is not handled by the snapshot extension.
• all license keys for optional software functions.
SW V6.0
OnAir 1500 Digital Mixing Console
Data Type File Name (SW V3.1 & up)
containerID_initial
containerID_initial
containerID_initial
containerID_initial
Audio (any individual name)
Input Routing (any individual name)
Output Routing (any individual name)
Assignment (any individual name)
Extension
.cfg
.ops
.usr
.key
.aud
.irt
.ort
.ass
chapter 6.5.26.1). If active,
Operation 5-31