Supported Audio Files; Files And File Names - Studer OnAir 1500 Operating Instructions Manual

Hide thumbs Also See for OnAir 1500:
Table of Contents

Advertisement

5.16.1.1

Supported Audio Files

5.16.1.2

Files and File names

Jingle Player
Track Player
Document generated: 06.08.14
All players/recorders listed above require audio files
properties:
• USB memory device formatted with FAT32 file system (also refer to
chapter
5.16.1.3); maximum file size is 4 GB.
• Maximum memory size is 2 TB.
• Wave or broadcast wave format, file extension 'wav'.
• Linear PCM coding; sampling rate 44.1 or 48 kHz (for recording, the
configured console sampling rate is used); word length is 16 or 24 bit for
playback and 16 bit for recording.
• REC / PLAY connector: Playback in stereo or mono, recording in stereo.
• MCH I/O connector: 8 channels in/out.
Audio files and their names must meet the following conditions:
Jingle audio files must be located within a root folder named Jingle (case-
insensitive). If the system cannot find this folder when the memory device is
connected, it is automatically generated but will be empty.
File names must begin with the character 'J' followed by a one- or two-digit
number (1-8 or 01-08) signifying the desk key it can be started with. The file
name extension must be .wav. The factory default configuration comprises
four desk keys (JINGLE 1 / 2, APPLAUSE and BOOing), as shown below.
Key 1
Key 2
The jingle tracks must comply with the file requirements indicated above.
Maximum file name length is limited to 60 characters, including the exten-
sion. The corresponding key is illuminated during playback of a jingle.
Examples:
J01_Logo_1.wav is the station logo that is played upon pressing the
JINGLE 1 desk key.
The J3applause.wav file is played upon pressing the APPLAUSE desk
key.
Please note: If two files should be present the names of which both begin
with the same key number (such as J03_Applause_44.1k.wav and
J03_Applause_48k.wav), the key assignment is undefined. When
pressing the APPLAUSE desk key any of the two files may be played then.
Tracks to be played must be located within a root folder named Music
(case-insensitive). If the system cannot find this folder when the memory
device is connected, it is automatically generated but will be empty. The file
name extension must be .wav.
These tracks must comply with the file requirements indicated above. If more
than 64 tracks should be located in this folder, some of them will be ignored.
Maximum file name length is limited to 60 characters, including the exten-
sion.
SW V6.0
OnAir 1500 Digital Mixing Console
Key 3
Key 4
with
the following
Operation 5-137

Advertisement

Table of Contents
loading

Table of Contents