Gui Watches; Time And Date Setting; Watch Configuration - Studer OnAir 1500 Operating Instructions Manual

OnAir 1500 Digital Mixing Console
5.8.5

GUi Watches

5.8.5.1

Time and Date Setting

5.8.5.2

Watch Configuration

5-44 Operation
If a user GUI screen is connected, the watch in the upper left corner of the
screen gives a permanent display of the current time and date. The standard
time reference is an internal real-time clock (RTC) with battery back-up.
The RTC continues to run when the console is switched off. Therefore, it
is unnecessary to set the watch on each power up. Three different display
modes (from left to right: analog, radio and digital clock), and two different
date formats (20.Jul.2010 or Jul-20-2010) are available, they can be selected
in the configuration tool
Both he meter bridge and user GUI watches are simultaneusly set in the
Admin - Date Time page (see
can be set:
• Time and date (only if free-running, i.e. Time Sync Source = None)
• Offset; used whenever a temporary offset between the actual watch time
and the time display is desired. If a temporary offset is set, the Offset
indicator in the upper right corner of the dial turns red, as shown left. This
offset is automatically reset to 0:00 when the console is restarted.
On the Admin - Date Time page, the selected time sync source is displayed
for reference.
The configuration tool allows specifying the time display mode and the time/
date format (User GUI - Settings, see
sync reference, a time zone selection, and automatic daylight saving time
switchover for use with NTP or Monitora synchronisation (Config - System
Time, see chapter 6.5.15).
Possible synchronization sources for the watch:
• None (i.e. free-running, controlled by the internal RTC). The sync indica-
tor is displayed in gray, as shown in
• Network (NTP time server)
• Monitora
In NTP and Monitora modes, the sync indicator is displayed in white on
black background, as shown in
turns red, as shown left.
SW V6.0
(see chapter 6.5.38.1).
chapter 5.12.8.4). The following parameters
chapter 6.5.38.1) as well as the time
chapter 5.8.5.1.
chapter 5.8.5. If the synchronization fails, it
Document generated: 06.08.14