Codec Management; Basics - Studer OnAir 1500 Operating Instructions Manual

Hide thumbs Also See for OnAir 1500:
Table of Contents

Advertisement

OnAir Digital Mixing Consoles
6.5.23

Codec Management

6.5.23.1

Basics

I/O Sharing
A/B desk
6-54  Configuration
Sharing of common codecs, either from independent systems with the I/O
sharing option, or from an A/B desk, is called codec management.
The concept is explained on a dual, I/O sharing system; the goal is that a
codec connected to system A may also be used on system B.
System B (Net Consumer)
N–X
NetLI
• Two logical I/O sharing connections (
• The net logical input (NetLI) on system B consumes the logical input (LI)
from system A.
• A net patch input (NetPI) on system A consumes the N–X bus of system
B that is specified as N–X control of NetLI.
This allows system B sending any signal to the codec, as long as NetPI is
routed to the patch output (PO) connected to the codec's input.
Both systems may 'listen' to the codec's output at the same time, but only
one system can provide its N–X bus output to PO. In the output routing, the
source for PO is either the I/O sharing NetPI, or the local N–X bus assigned
to the producer system's (local) LI.
The source for PI is usually controlled on the desk where LI or NetLI is locat-
ed. It may also be controlled from the Routing - Output page of system A
to which the codec is directly connected (MCR).
Note:
A logical output (LO) could also be used instead of a patch output (PO) for
the connection to the codec's input. However, since patch outputs are not part
of the output routing snapshot, they will not be affected by loading an output
routing snapshot on system A.
In case of an A/B desk configuration, I/O sharing is not required. Both desks
may 'listen' to the codec's output at the same time – logical input A (LI A)
on system A, and logical input B (LI B) on system B. Only one system can
provide its N–X bus output to the patch output (PO). In the output routing,
the source for PO is either the N–X B bus specified as N–X control in LI B,
or the N–X A bus assigned to LI A.
A/B System
N–X A
N–X B
LI B
LI A
SW V6.0
System A (Net Producer)
NetPI
LI
PO
N–X
PO
) are required.
Document generated: 06.08.14

Advertisement

Table of Contents
loading

Table of Contents