Studer OnAir 1500 Operating Instructions Manual page 233

OnAir Digital Mixing Consoles
6-14 Configuration
Then a list for selection of the desired physical input appears . It can be
scrolled up and down with the rightmost rotary encoder or the navigation
buttons at its upper and lower margins. However, when using a Remote
Configuration Tool running under Windows XP, the navigation buttons are
replaced by a vertical scrollbar.
Indication example: Frame (Int = internal I/O cards in SCore frame; Ext # =
additional, external D21m frame; StageBox # = D21m frame in stagebox),
Slot #, Card type, and Input # (e.g. Int, Slot 1, AES, Ch. 1), or '-' (if no
physical input is assigned to the logical input).
If more sources are assigned to a physical input than are defined by the Input
Format field (e.g. an additional right source for a mono input), these sources
will be displayed in gray.
An external frame or a stage box may have a name different from the default
name, depending on what name was given to the D21m hub or stage box
during their configuration.
If, on the other hand, a shared Net Source has been selected, first a systems
dialog list appears, showing the available I/O sharing-enabled systems that
also have physical connections defined.
Since all sources consumed by one I/O sharing input need to be from the same
system, this systems dialog only appears when defining the first source.
Now, select a source group from the desired I/O sharing producer system.
After that, the available logical inputs of the producer system are listed for
selection.
A format dialog appears in case of a Source (Left); for the further sources
it appears only if the selected source provides more than one signal.
At last, the connection is selected. Automatic only appears if Source (Left)
was selected first; then the remaining sources are filled in automatically. The
list also offers buttons for selecting individual mono signal legs for every
single source.
Since all sources consumed by one I/O sharing input need to be from the same
system, this systems dialog only appears when defining the first source.
SW V6.0 Document generated: 06.08.14