Core Rear View - Studer OnAir 1500 Operating Instructions Manual

3.3

Core Rear View

MIC/LINE IN
AES/EBU IN / OUT
AUTOMATION
DESK / EXTENSION / TB BOX
DVI and USB
100-240V ~ 100W 50-60Hz
GPI / GPO 1-8
Date printed: 06.08.2014
The rear side of the Nano SCore features the following elements:
16 electronically balanced inputs on female XLRs with remote-controlled
individual gain, low-cut filter and 48 V phantom power.
16 electronically balanced line outputs on male XLRs with globally jumper-
LINE OUT
selectable output level.
Please note that the line outputs no. 10-16 are per default assigned to moni-
toring lines (10: (SPEAKER), 11/12: CR MON LS, 13/14: ST MON LS, 15/16:
ST DJ HP).
4 stereo AES/EBU digital inputs and outputs each.
SYNC 3 different external SYNC inputs:
AES for synchronization to an external AES/EBU signal on a female XLR,
WCLK IN for synchronization to an external word clock signal on a BNC
socket (looped through to WCLK THRU for daisy-chaining several units),
VIDEO IN for synchronization to an external video signal on a BNC socket.
For syncing external units to the internal word clock, WCLK OUT is used.
9-pin D-type connector for communication with a CAB system.
3 RJ45 sockets for the links to the desk, to an optional 6-fader extension unit
and to an optional, external talkback box.
These sockets may be used for a computer screen, keyboard and mouse. They
are used for the initial console setup or later, if an individual system configu-
ration is required. They can also be thought of as an emergency scenario if
the desk should fail – the user GUI is very similar to the one known from the
OnAir 2500 and OnAir 3000 consoles, with the exception that, of course, the
computer screen has no touch functionality.
ETHERNET RJ45 network socket used for RELINK (I/O sharing) and other networked
applications.
Mains input on an IEC 320/C13 socket.
Main power switch for the whole system.
MAIN
GND 4 mm ground/earth terminal.
24V EXT Connector for an external 24 V DC power supply (may be used for redundant
supply, too).
11, 12 D21m card slots for two single-width or one double-width card(s) for input
and/or output expansion.
General-purpose inputs and outputs for control signals, such as red light or
fader start.
SW V6.0
OnAir 1500 Digital Mixing Console
Setup 3-5