Studer OnAir 1500 Operating Instructions Manual page 82

OnAir 1500 Digital Mixing Console
Guest Headphones
Internal Speaker
LSP Split Mode
MON or HP SPLIT=off
SP SRC / MON or HP SPLIT=on
5-26 Operation
The guest headphones are always fed with the same signal as the CR monitor
speakers, but without cut or dim functions.
GUEST HP For setting the guest headphone's level, the HP VOL knob is used while press-
ing the GUEST HP button. The adjusted level is indicated by the knob's LED
ring.
The PFL and talkback return signals are mixed and fed to the internal speaker.
If the PFL signal is listened on the CR monitor speakers, it is automatically
muted on the internal speaker.
If the CR red light is active, the internal speaker is automatically muted.
For setting the internal speaker's level, the HP VOL knob is used while press-
SP
ing the SP button. The adjusted level is indicated by the knob's LED ring.
If pressed, the corresponding contribution level to the internal speaker is
TB RET
indicated on the LED ring around the HP VOL knob and can be adjusted
individually. The mix ratio of the PFL and talkback return signals also influ-
ences the TB return signal on the DJ headphones.
If enabled in the Configuration Tool (see
the CR monitor speaker signals to be split depending on the HP Split Mode
in a similar way as for the headphones.
With PFL TO MON not active, the LSP Split mode does not affect the CR
monitor speakers at all.
With PFL TO MON active, PFL and the HP SPLIT button or the HP Split Mode
selector in the UserGUI, see
as follows :
CR monitor speakers provide the stereo signal selected by the source selector
as long as no PFL is active. Otherwise, the stereo SP SRC
CR monitor speakers.
Activating PFL on any channel provides two mono signals to the CR monitor
speakers. The left
the right
**
monitor speakers by the source selector. If the SP SRC
the CR monitor signal or no PFL is active, the CR monitor speaker signal is
the stereo CR monitor signal as if MON were active (see above).
Sames as MON
SP SRC
The CR monitor speaker signals (left/right) are according to the following
table:
CR monitor speaker signals (LSPSplitEnable = active)
PFL To Mon
OFF
OFF
OFF
ON
ON
ON
The SP SRC signal is PFL, if PFL is active on any channel and CR PFL to
*
SP SRC is enabled in the Configuration Tool otherwise it is the selected SP
SRC.
SW V6.0
chapter
loudspeaker signal is the mono SP SRC
**
one is a mono mix of the CR monitor signal as selected for the CR
HP Split Mode
(selectable in GUI)
MON
SP SRC
SP SRC/MON
MON
SP SRC
SP SRC/MON
chapter 6.5.24.1), this mode enables
5.12.4.3, affects the CR monitor speakers
signal is fed to the
*
signal is the same as
*
Signal when PFL is Signal when PFL is
not active active
stereo MON stereo MON
stereo MON stereo MON
stereo MON stereo MON
stereo MON ST SP SRC*
stereo MON ST SP SRC*
stereo MON M SP SRC*/ M MON **
Document generated: 06.08.14
signal, while
*