Cab Extension; Probel Controller Extension; Cms Controller Extension; I/O Sharing - Studer OnAir 1500 Operating Instructions Manual

5.11.4.12

CAB Extension

Error Code Error Type Error Text / Comment
8001
Warning
8100 Warning
8101
Warning
8102
Warning
8103
Warning
8104
Warning
5.11.4.13

ProBel Controller Extension

Error Code Error Type Error Text / Comment
8200
Warning
8201
Warning
8202 Warning
5.11.4.14

CMS Controller Extension

Error Code Error Type Error Text / Comment
8301
Warning
5.11.4.15

i/O Sharing

Error Code Error Type Error Text / Comment
8500
Warning
8501
Warning
8503
Warning
Document generated: 06.08.14
CAB, Broadcast Automation disconnected.
CAB (Monitora protocol), SELECT_SOURCE failed: No free stripchannel.
CAB (Monitora protocol), SET_SAS_INPUTROUTING failed: HD-Link signal ID out of range. InputLine can-
not be routed.»
Appears on reception of a SET_SAS_INPUTROUTING message if at least one of the required HD Link
Ins is out of range (e.g. the required HD Link In for right surround channel is 97 but only one DSP Card is
installed).
CAB (Monitora protocol), Could not open port COMX.
Appears during init phase if the specified COM port cannot be opened. This can happen if the ProBel con-
troller extension is running within the same container as the CAB extension.
CAB (Monitora protocol), SELECT_SOURCE failed: No free DSP channel.
CAB (Monitora protocol), Invalid Logic Assignment configuration for input LI1: item. Assignment is ignored.
Appears if any errors regarding Logic Assignments are found during parsing of the cab_interfaces.ini file.
Possible items:
- Monitora command not availble
- Level producer not available
- Logical Input not available
PROBEL Controller, Could not open port COMX.
Appears during init phase if the specified COM port cannot be opened. This can happen if the CAB exten-
sion is running within the same container as the ProBel controller extension.
PROBEL Controller, "Master Channel Base" conflicts with logical input or patch input numbers.
Appears during init phase if the tree parameter "Master Channel Base" ss maller than the input number of
the last logical output. Set "Master Channel Base" to an appropriate value.
PROBEL Controller, Connection lost to External Router Control System (RCS)
If all redundant systems of a session/facility does not answer anymore or the connection of the session is
lost.
CMS Controller, Connection lost to external Call Management System (CMS)
If the CMS Client of a session/facility does not answer anymore or the connection of the session is lost.
IOSHARING, Did not find XML-file: xml\IoSharing.xml
Appears during power up if IoSharing.xml could not be found.
IOSHARING, Could not reset physical connection, since it is still in use!
The HD LINK Out parameter of an HD LINK Input may only be changed if the parameter "UsageCounter"
of the HD LINK Input is = 0. Otherwise this warning will appear.
IOSHARING, I/O Sharing not enabled on system ‚P422'. Missing dongle or license key. IO-Sharing will not
work properly.
Appears if the specified system (either the local system which is the consumer or the producer) has no
dongle on the audio clock card and no key is defined to enable I/O Sharing.
SW V6.0
OnAir 1500 Digital Mixing Console
Operation 5-71