Studer OnAir 1500 Operating Instructions Manual page 297

OnAir Digital Mixing Consoles
GPI Function
1: Logical Input / Strip Channel / AUX / N–X
ExtON
UserLED
ExternOnAir
Outgate
PFL
Ready
* ManualDucking
EnableOutput
Routing
ChannelUserLED
UserKey
ChannelUserKey
* OnAir 3000 only
GPI Function
LinkInput
6-78 Configuration
Defined by Triggered Edge and Action Settings (Toggle)
In contrast to the GPInput Functions specified in 'Defined by Triggered Edge
and Action Settings (InputLevel)' below, these functions toggle the specified
DNet parameters in cases where Triggered Edge is not BOTH and Action is
ALTERNATE.
Arguments
1: User LED device ID ('function')
–
1: GP Output Pin
1: Logical Input / Strip Channel / Master /
/ Ext PFL
2: PFL CR / PFL Studio
1: Logical Input
1: SubGroup1...8
1: Desk Group 1...8
1: Logical Input / Master
2: User Function 1 / User Function 2
1: User Function
1: Logical Input / Master
Defined by Triggered Edge and Action Settings (InputLevel)
In contrast to the GPInput Functions specified in 'Defined by Triggered Edge
and Action Settings (Toggle)' above, these functions set the specified DNet
parameters according to the InputLevel given by the Input Logic in cases
where Triggered Edge is not BOTH and Action is ALTERNATE.
Arguments
1: GP Input Pin
SW V6.0
Description
Parallel to the ON key in the channel strip
Sets the specified User LED parameter according to the GP
input signal.
This function connects the signal of a GP input pin to a User LED
Parameter. If the LED of a user key on the desk (e.g. Fader Assign
Module) is assigned to that parameter, the input can provide a
status feedback to the LED of a user key (also refer to the 'UserKey'
GPO function).
ON AIR LED activation (configured in 'Signaling Settings')
Output x is only active if the Out function is active and the
Gate input is active
PFL control signal from the CAB system is active
External source is ready for playback
External control of manual ducking
Sets the enable parameter of the corresponding DeskGroup
Sets the specified User LED Parameter according to the GP
Input signal.
This function connects the signal of a GP input pin to the specified
Channel User LED parameter of the specified channel. If the LED
of a user key on the desk (e.g. Fader Module) is assigned to that
parameter, the GPI can provide a status feedback to the LED of a
channel user key (also refer to the 'ChannelUserKey' GPO function).
External control of the User Key status
External control of the Channel User Key status
Description
Links the GP input to an existing GP input function (e.g. when
two keys shall be used for an On/Off function).
Tree Parameter: GPIOFunctions - GPInputFunctions -
GPInputFunctionX - FInputLogic - InputLevel.
If Triggered Edge of the corresponding GPInput Pin equals 'both',
InputLevel is set according to InputLevel (momentary).
Otherwise, if Action is either ACTIVATE or DEACTIVATE, InputLevel
is set according to Action.
Otherwise, InputLevel is set to InputLevel.
In a case where two GP Inputs are linked, the Action of the GP Input
Functions should be configured in such a way that one function
activates the InputLevel and the other deactivates it.
Document generated: 06.08.14