Canon VB-R11VE Operation Manual page 202

If necessary, configure the [Exposure Lock], [White Balance Lock] and [Focus Lock] settings used when capturing
1
the panorama image.
These settings will be applied at the panorama image capture start time and will revert back to their previous
settings once capture is completed.
(1) [Exposure Lock]
The exposure for the selected position will be automatically adjusted and locked during capture.
(2) [White Balance Lock]
The white balance for the selected position will be automatically adjusted and locked during capture.
(3) [Focus Lock]
The focus for the selected position will be automatically adjusted and locked for the entire scene during
capture.
2 Click [Start Panorama Creation].
Capture starts and the panorama image is created.
To stop capture while underway, click [Cancel].
Note
• While a panorama image is being captured, the Image Stabilizer is temporarily disabled.
• The following users will be disconnected while creating a panorama image.
– All users except for administrators
– Users not connected via RTP
• When a small value is entered for [Maximum Frame Rate: Video Transmission] (P. 73) in [Video Settings] > [JPEG] in the Setting
Page, panorama capture is slowed down.
3 Recapture the image if necessary.
Recapture a part of the image:
When you position the mouse pointer over the panorama image, a white grid appears.
If you right-click on a part of the image and select [Recapture] from the menu that appears, only that part of the
image will be recaptured.
202
(1)
(2)
(3)