Canon VB-R11VE Operation Manual page 131


Mount Status
The memory card will be automatically mounted when you insert it into the memory card slot. It will also be
automatically mounted if it has been inserted in the memory card slot when the camera starts up.
[Mount/Unmount]
Click [Unmount] to unmount the memory card.
Be sure to unmount the memory card when turning off the power to the camera or removing the memory card.
[Operation Settings]
Select the data to save to the memory card.
For details on the video saved when [Save Logs and Videos] has been set,
Organization of Memory Card" (P. 250).
Note
New files cannot be saved to the memory card if there is no free space.
[Video Format]
Select the video format to record to a memory card.
Video is recorded in this format when [Video Record Action] is set to [Record to Memory Card].
Video size and quality of the recorded video follow the settings in [Video Settings] (P. 72).
Important
For [H.264(1)], the following settings must be configured in [Video Settings] > [H.264(1)] (P. 73).
– [Bit Rate Control]: [Use bit rate control]
– [Target Bit Rate (kbps)]: [3072] or less
– [I Frame Interval (sec)]: [0.5], [1] or [1.5]
Note
• When set to [JPEG] and an upload error occurs, the frame rate of video recorded in JPEG format is always 1 fps.
• When a network error occurs interrupting the transmission of recording-mode stream video, video is saved in the JPEG format
regardless of the [Video Format] setting (the frame rate is fixed at 1 fps).
[Pre-event Buffer (number of frames)] (JPEG)/ [Pre-event Buffer (sec)] (H.264(1))
Enter the number of frames or seconds of video to be buffered before the event.
Enter the maximum number of frames for [JPEG] or the maximum number of seconds for [H.264(1)] in [Video
Format].
Depending on conditions, however, saving the set number of frames or seconds may not be possible.
[Post-event Buffer (number of frames)] (JPEG)/ [Post-event Buffer (sec)] (H.264(1))
Enter the number of frames or seconds of video to be buffered after the event.
Enter the maximum number of frames for [JPEG] or the maximum number of seconds for [H.264(1)] in [Video
Format].
Depending on conditions, however, saving the set number of frames or seconds may not be possible.
"Saved Data and Data
please refer to
4
131