Canon VB-R11VE Operation Manual page 135

• 802.1X
Note
• It is recommended that you note down each current setting before you click [Exec] in [Restore Default Settings].
• The camera can be restored to factory default settings using the reset switch as well. Note, however, that this will reset all camera
settings to factory default settings except for date and time (P. 270).
[Back Up Settings]
All settings, except date and time, will be backed up to the memory card.
The IP address, certificates used by SSL and 802.1X and private key will also be backed up.
[Restore Settings]
Restores all settings, except date and time, from the memory card backup file created with [Back Up Settings].
The IP address, certificates used by SSL and 802.1X and private key will also be restored.
After restore is completed, the camera will be rebooted.
Important
If you restore a backup file from another camera, you may encounter problems, such as address collisions on the network.
R11
[Refresh Drive System]
Cleans the connection parts inside the camera.
When [Exec] is clicked, the pan operation is performed for two cycles each of left and right and then the camera returns to
the camera angle before execution when the operation completes.
Using this may be effective if panning causes problems with the video and audio.
Note
The following users will be disconnected while refreshing the drive system.
– All users except for administrators
– Users not connected via RTP
R10
4
135