Table of Contents
Advertisement
Figure 4-12: Flash Descriptor Security Override Jumper Location
To update the ME firmware, please follow the steps below.
Step 1:
Before turning on the system power, short pin 2-3 of the Flash Descriptor
Security Override jumper.
Step 2:
Update the BIOS and ME firmware, and then turn off the system power.
Step 3:
Remove the metal clip on the Flash Descriptor Security Override jumper or
return to its default setting (short pin 1-2).
Step 4:
Restart the system. The system will reboot 2 ~ 3 times to complete the ME
firmware
update.Step 0:
4.4.4 mSATA Setup Jumper
The mSATA setup jumper specifies whether to automatically detect the mSATA device
installed in the PCIe Mini slot (CN2). If the user shorts the mSATA setup jumper to force
the system to enable mSATA device, the SATA4 connector will be disabled.
Setting
Open
Short 1-2
Table 4-3: mSATA Setup Jumper Settings
Page 68
Description
Automatically detect mSATA device (Default)
Force to enable mSATA device
(The SATA4 connector will be disabled)
IMBA-H810 ATX Motherboard
Advertisement
Table of Contents
