Clear Cmos Button; Flash Descriptor Security Override; Figure 4-11: Clear Cmos Button Location; Table 4-1: At/Atx Power Mode Switch Settings - IEI Technology IMBA-H810 User Manual

IMBA-H810 ATX Motherboard
Setting
1-2
2-3

Table 4-1: AT/ATX Power Mode Switch Settings

4.4.2 Clear CMOS Button

To reset the BIOS, remove the on-board battery and press the clear CMOS button for
three seconds or more. The clear CMOS button location is shown in Figure 4-11.

Figure 4-11: Clear CMOS Button Location

4.4.3 Flash Descriptor Security Override

The Flash Descriptor Security Override jumper (J_FLASH1) allows to enable or disable
the ME firmware update. Refer to Figure 4-12 and Table 4-2 for the jumper location and
settings.
Setting
Short 1-2
Short 2-3

Table 4-2: Flash Descriptor Security Override Jumper Settings

Description
ATX power mode (default)
AT power mode
Description
Disabled (default)
Enabled
Page 67