Table of Contents
Advertisement
Figure 4-2: Remove Protective Cover
Step 3:
Inspect the CPU socket. Make sure there are no bent pins and make sure the
socket contacts are free of foreign material. If any debris is found, remove it with
compressed air.
Step 4:
Orientate the CPU properly. The contact array should be facing the CPU
socket.
WARNING:
DO NOT touch the pins at the bottom of the CPU. When handling the
CPU, only hold it on the sides.
Step 5:
Correctly position the CPU. Match the Pin 1 mark with the cut edge on the
CPU socket.
Step 6:
Align the CPU pins. Locate pin 1 and the two orientation notches on the CPU.
Carefully match the two orientation notches on the CPU with the socket
alignment keys.
Page 60
IMBA-H810 ATX Motherboard
Advertisement
Table of Contents
