Front Brake Discs - MV Agusta Brutale 675 Workshop Manual

Unscrew the pin and remove it; then remove the brake
lever.
When reassembling take care to insert the
lever into its seat.
Grease the pin:
Recommended grease: Agip Grease 30
Insert the pin into the seat and screw it in until the beat
is reached, then tighten the nut by using a screwdriver.
Front brake lever nut torque pressure:
8 ÷ 10 N • m

FRONT BRAKE DISCS

Check the thickness of the front discs utilising a
micrometer gauge and measure three points at least
with 120° between them as shown in the figure.
Use a micrometer gauge for this check.
- Minimum allowable thickness: 4.5 mm
This operation just be carried out on both front discs.
If the measurements are below the mini-
mum, substitute the component with a new
one.
Brakes
- 15 -
8÷10 N•m
H