MV Agusta Brutale 675 Workshop Manual page 327

To assemble the brake caliper-carrying flange, carry
out the following operations:
Grease the O-rings and insert them into their respec-
tive seats on the flange.
Assemble the rear spacer ring in contact with the hub,
then the brake caliper-carrying flange, the second
spacer ring and the Seeger retaining ring (1).
It is important to ensure that the Seeger retaining ring
is inserted around the whole circumference of the seat.
Grease the rollers bearings.
Introduce the first bush, the spacer and then the sec-
ond bush.
The grease used must have the following
characteristics:
– Lithium soap grease with a mineral oil base
– Consistency NLGI: 2
– Dripping point: 181° C
– viscosity at 37.8°C: 140 cSt
– Temperature field: from -25°C to +120°C
Reassembly rear wheel pin
Grease the wheel pin in the two tracks where the bear-
ings slide and gently insert it into the hub; at the same
time, from the left side, position the ring gear unit that
is already engaged on the chain. Finish inserting the
wheel pin until you feel it reach the end.
Suspension and wheels
- 73 -
1
F