MV Agusta Brutale 675 Workshop Manual page 261

Mount the flange, spacer ring and nut utilising a 14 mm
spanner and a 27 mm spanner and extract the bearing
as shown in the figure.
Operate in the same way on both bearings.
NOTE
Check that the ends of the aluminium spacer and the
seats of the bearings on the wheels are not scored or
marked.
Reassembly – front wheel bearings
Before proceeding with the reassembly, accurately
clean the bearing seats in the wheel hub.
Lubricate the outer ring of both bearings with special
grease.
Mount the bearing on the specific tool and insert it in
the rim housing.
Recommended product: Agip Grease 30
Special tool No. 8000B4421
Mount the bearing and a spacer on the specific tool.
Special tool No. 8000B4421
Suspension and wheels
- 7 -
F