MV Agusta Brutale 675 Workshop Manual page 126

Once the half-handlebars have been adjusted, insert
the screws in the corresponding fixing bores as shown
in the picture.
Tighten the screws at the prescribed torque.
Half-handlebars central plate screws torque:
9 ÷ 10 N·m
C
Apply loctite 243
- Half-handlebars removal (Dragster 800)
To remove the half-handlebars, after removing the
fixing screws of the central plate it is necessary to carry
out the operations described as follows.
Remove the central plate.
Remove the fixing screws of the half-handlebars by
keeping fixed the nut on the lower side of the steering
head.
when reassembling, tighten the screws at
the prescribed torque.
Half-handlebars fixing screws torque:
38 ÷ 42 N•m
Remove the half-handlebars from the vehicle.
Superstructures
- 12 -
Position "+1"
9 ÷ 10 N•m
Position "-1"