Instrumentation - MV Agusta Brutale 675 Workshop Manual

Electrical system
Remove the connector holding device.
E
With the switch in the RUN position make sure there is
continuity between the Y/R (yellow/red) and Y/W (yel-
low/white) wires.
Holding the START button down, make sure there is
continuity between the Y (yellow) and W/R (white/red)
wires.

INSTRUMENTATION

If faults are found in the instrumentation, it is necessary
to check the main wiring and the various components
2
assisted by the same instrumentation. To carry out the
various checks after having removed the headlamp
and the dashboard as described in chapter C
"Bodywork", it is necessary to remove the rubber cap
(1) and then the connector (2) situated behind the
instrumentation.
1
- 31 -