Removing Rearview Mirrors (Dragster 800) - MV Agusta Brutale 675 Workshop Manual

REMOVINg REARVIEw MIRRORS
(DRAgSTER 800)
Disassemble the brake lever guard by removing the
two fixing screws from the RH rearview mirror support.
Repeat the operation on the other side of the motorcy-
cle for the removal of the clutch lever guard.
when reassembling, tighten the screws at
the prescribed torque.
Brake/clutch lever guards screws torque:
3 N•m
Apply loctite 243
Remove the fixing screw of the rearview mirror support
from the RH half-handlebar.
Remove the support complete with rearview mirror.
Repeat the operation on the other side of the motorcycle.
when reassembling, be careful to correctly
insert the rearview mirror support in the cut
on the half-handlebar block and tighten the
screw at the prescribed torque.
Rearview mirror support screw torque:
12 N•m
Apply loctite 243
When replacing the rearview mirror, remove the lower
fixing screw as shown in the picture.
when reassembling, tighten the screw at the
prescribed torque.
Rearview mirror fixing screw torque:
8 N•m
Apply loctite 243
Superstructures
- 13 -
C