MV Agusta Brutale 675 Workshop Manual page 314

Slide out in a forward position as shown in the figure.
During re-assembly, proceed in reverse order making
sure that the two front and rear reference elliptical ele-
ments are in the correct position.
Lower chain guide removal
F
Remove the 3 screws (1) with their relative spacers.
Bearings overhaul
If it is necessary to substitute the bearings of the
swingarm because of excessive play, operate as fol-
lows:
Remove the right and left spacer.
Remove the Seeger retaining ring on the right side of
the swingarm.
Remove the anti-dust seal on the left side.
Utilising the special tool, remove the two roller bearing
units.
Special tool N. 800092860 LEFT SIDE
Mount the tool so that both roller bearings are
removed.
Suspension and wheels
- 60 -
1